What’s New in Version 2.0

Control of Head Amp Gain for each Input Channel.

Scene Memory Management – Store, Recall, Scene Titles and Comments.

This version of StageMix is for use with M7CL FIRMWARE V3.5 OR HIGHER

Mixer Window

The main page of the StageMix is called the “Mixer” window. It shows the EQ curve, CUE and ON buttons, fader and level meters, and channel names for eight adjacent channels.
Across the top of the screen, all Input, Mix and Matrix level meters and faders are displayed in blocks of eight. This is the “Navigation/Meter Bridge”. Press any of these blocks to select which channels are viewed in the fader strips below.

SENDS ON FADERS

The color of this button matches those used on the M7CL console. [CUE] and [ON] buttons appear below, allowing the currently active Mix or Matrix bus to be Cued and turned On/Off.

EQ Editing

Parametric EQ
One band of EQ can be adjusted at a time. Press one of the green circles to select the band, and it will be highlighted yellow. EQ bands in StageMix are labelled as follows:
– HP = HPF (input channels only)
– 1 = Low Band
– 2 = Low-Mid Band
– 3 = High-Mid Band
– 4 = High Band

Graphic EQ
The upper section of the GEQ setup screen shows GEQ curves and gain levels of all 31 bands. White dot indicates the level position of each band. You can set up each band level by faders shown below it. Settings can be done up to 10 bands at once. Slide the screen to select different bands.

Head Amp Gain

The head amp gain for each input channel can be controlled using the faders in StageMix. Press the [HA GAIN] button in the lower left portion of the Mixer window to enter HA GAIN mode. This button will turn red and the background behind the channel faders will become red to indicate that StageMix is in HA Gain control mode.

Scene Memory

From this screen, the parameters on the console can be stored to the Scene Memory, which can also be recalled to the console when selected. Scene Titles and Comments that are shown on this screen can be edited easily by tapping on them.